Mono-BlockTM II+

The Mono-Block™ III manifold is a low cost solution to chemical additive injection in the petroleum terminal environment. This manifold design meets the entire standard requirements for metering and control of a cyclical injection chemical stream.

 The Mono-Block™ III provides an electrically operated solenoid valve and a precision fluid meter in a common manifold. In addition, the manifold includes an inlet strainer, a calibration security diverter valve with integral flow control and an outlet check valve. 

Combining this functionality into a single manifold block reduces the size of the instrumentation. This is critical in the limited spaces available on truck loading racks today. Additionally, combining the solenoid, meter, and test port into a single manifold eliminates most potential leak points common to component built injectors assembled in the field. 

This manifold block provides the physical instrument needed to allow a Terminal Automation System, Preset, or PLC System to directly control chemical additive injection. This manifold does not include the electronics control necessary to pace the chemical to a flowing fuel stream, nor does it contain the logic necessary to accumulate additive volume passing through it.

 AC line voltage is typically used to energize the solenoid valve and allow fl ow. The controlling device (e.g. Mini-Pak Controller) then accumulates flow volume in the form of pulses transmitted from the meter sensor. When sufficient volume of additive chemical has moved through the manifold, the controlling device then turns off the solenoid valve in order to stop flow. 

It is the responsibility of the controlling device, Terminal Automation System, Preset, or PLC System, to perform the algorithms necessary to ratio the chemical properly into the fuel stream. 

Functionality for recipe, injection interval, tolerance, alarm annunciation, shutdown, etc. are all the responsibility of the controlling system. 

If the controlling system is not capable of this level of function, manifold blocks alone are not the solution. 

The user should consult our factory for information on complete injection panels that include microprocessor based controllers having the capability of complete injection control.